Processing methods and skills of large aluminum alloy parts

         What are the processing methods for large aluminum alloy precision parts? To make large aluminum alloy parts, the clamping method should be reasonable first. If you can use a flying knife to open it, try to use a flying knife. This can also improve efficiency. Crude. After roughing, flatten the planes of the two surfaces to ensure that the workpiece is vertical and then make a smooth knife. The thickness allowance should be left enough to ensure that if an abnormality occurs during processing, there is a possibility of remedy.

     The clamping must be stable, the fly knife has a large amount of rough cutting to prevent the workpiece from moving during the processing, and always observe whether there is any sticking of the knife. After the fly knife is roughed, use the calibration meter to check the balance. Pay more attention to the structure of the workpiece to predict the position that may bounce in advance. Set the speed and feed parameters reasonably to avoid overcutting of the bomb knife. When machining the reverse side, the empty and thin part of the workpiece should be supported to avoid the impact of the bullet knife. Every detail must be paid attention to, because the cost and time of abnormal loss of processing large aluminum alloy parts are extremely large. Be cautious. Use aluminum knives as much as possible for the tool. If there are deep holes and deep grooves, you must pay attention to blowing chips in time to avoid tool slag. Huazheng Precision has professional and fast solutions for processing various large-scale aluminum alloy cavity parts, specializing in various difficult and high-precision parts, and has a professional team in the industry, excellent equipment, precise testing instruments and professional aluminum alloy Processing experience, welcome everyone to come to pictures and call at any time to place orders for custom processing!