Environmental requirements of CNC machine tool processing

       CNC lathe processing temperature standard. The operating temperature of CNC lathe processing is not less than 30 degrees Celsius, and the relative humidity must be less than 80%. Under normal circumstances, an exhaust and cold air system is installed inside the electrical box of the CNC lathe to maintain a constant operating temperature of the electronic components and small temperature changes. Excessive temperature and environmental humidity changes will cause the components of the automatic control system to reduce the service life, and the mechanical and fault frequency will increase, the temperature and environmental humidity will increase, and the increase of dust will cause short circuit phenomenon in the integrated circuit board.

      CNC lathe processing is the standard for the environment. The processing position of the CNC lathe must be far away from the vibration source, and the hazards of direct sunlight and heat radiation should be avoided. The position of the lathe must be placed to avoid the hazards of moisture and airflow. If there is a vibration source near the CNC lathe, it must be set on the four-axis of the lathe Anti-vibration groove, otherwise it will affect the use of later lathes, resulting in machining errors, unstable precision and inaccurate precision due to vibration, and also lead to poor contact of electronic components, mechanical failures, and affect the machining efficiency and reliability of the machine Performance and service life. .

       The use of CNC lathes is standardized. During the machining process, it is strictly prohibited to change the parameters set by the internal manufacturer of the automatic system at will. The setting of these parameters is directly related to the dynamic characteristics of the various parts of the CNC lathe. Only the gap compensation parameter value can be adjusted according to the actual use.

      The power requirements of CNC lathe processing. Conventional CNC lathes are installed in the processing workshop, and the temperature changes greatly. If the power supply with standard deviation and more electromechanical equipment is used, it will cause large fluctuations in the power grid. Therefore, the specific location of the CNC lathe must be strictly controlled by the power supply, and the power supply voltage must be fluctuated within Within the controllable range, and maintain stability, otherwise, it will endanger the normal operation of the CNC system.